Sharp MX-M850 User Manual page 42

Loading tab paper and transparency film
In addition to plain paper, tab paper and transparency film can also be loaded in the large capacity trays (MX-LCX5).
This section explains the procedures for loading tab paper and transparency film, and points to note.
Loading tab paper
To use tab paper, the special guide must be attached as explained below.
1
2
[Example]
Make sure that the positions of the tabs correspond with the originals as shown below.
3
Gently push the tray in and set the paper type to tab paper.
4
Change the paper type setting to tab paper as explained in
Loading transparency film
When loading transparency film, load the film in the vertical orientation with the rounded corner at the top
right.
Originals
1st sheet 2nd sheet 3rd sheet
42
Take out the tab paper guide.
The guide is stored inside the large capacity trays (MX-LCX5).
Open the cover and take out the guide. When finished using
tab paper, be sure to replace the guide.
Adjust the paper guide to the tab paper
size and load tab paper.
To adjust the paper guide, see
paper size (page 40).
Place the tab paper with the print side face up so that the tab is
to the right.
Tab paper
Bottom
1st sheet
Top
4th sheet
2nd sheet 3rd sheet
Attach the guide to the tray.
Attach the guide over the paper.
"PAPER TRAY SETTINGS" (page 80) in the System Settings.
Loading paper and changing the
Front
side
4th sheet