Sharp MX-M850 User Manual page 28

Paper that cannot be used
• Special media for inkjet printers
(fine paper, glossy paper, glossy film, etc.)
• Carbon paper or thermal paper
• Pasted paper
• Paper with clips
• Paper with fold marks
• Torn paper
• Oil-feed transparency film
Non-recommended paper
• Iron-on transfer paper
• Japanese paper
• Various types of plain paper and special media are sold. Some types cannot be used with the machine. Contact your
dealer or nearest SHARP Service Department for advice on using these types of paper.
• The image quality and toner fusibility of paper may change due to ambient conditions, operating conditions, and paper
characteristics, resulting in image quality inferior to that of SHARP standard paper. Contact your dealer or nearest SHARP
Service Department for advice on using these types of paper.
• The use of non-recommended or prohibited paper may result in skewed feeding, misfeeds, poor toner fusing (the toner
does not adhere to the paper well and can be rubbed off), or machine failure.
• The use of non-recommended paper may result in misfeeds or poor image quality. Before using non-recommended paper,
check if printing can be performed properly.
Tray during paper feeding
Do not pull out a tray while paper is being fed from the tray. This will cause a paper misfeed.
Tray 1 and tray 2 are joined together, so do not pull out the trays while paper is feeding from either tray.
Identifying the tray that is being used to feed paper
(1) While paper is feeding, the job status display of the system bar on the touch panel screen will show the number of
the tray that is being used to feed paper. However, this will not appear when the base screen of image send mode
appears. To show the tray number in this case, change to the base screen of a different mode, or change to the job
status screen (page 16) and select the [Print Job] tab in the mode select tabs.
(2) During output in copy mode, the tray being used to feed paper also appears in green in the paper size display in the
base screen of copy mode on the touch panel.
Example: Base screen of copy mode
Plain
Plain
Exposure
Auto
Copy Ratio Original
100%
Auto
8½x11
Tray2
Special Modes
Plain
2-Sided Copy
8½x11
5.
11x17
Output
1. 2. 6.
8½x11 8½x11 11x17
11x17
3. 7.
File
8½x14 11x17
4.
Quick File
Paper Select
Auto
8½x11
Plain
• Thin paper less than 13 lbs. (52 g/m
• Paper heavier than 301 g/m
• Irregularly shaped paper
• Stapled paper
• Damp paper
• Curled paper
• Paper with a wave-like pattern due to moisture
absorption
• Reverse side of paper already printed on by another
printer or copier.
• Perforated paper
(1) Job status display on the system bar
Shows the number of the tray being used to feed paper.
(2) Paper size display
Shows the tray being used to feed paper in green.
28
2
)
2
.