Choosing The Circuit Type; Pvc Configuration; Setting The Lmi Protocol - HP auroraTempo User Manual

Choosing the Circuit Type

You can select from a list of circuit types. Your selection
determines what options are available from the Link
Configuration menu (for example, if you choose SVC,
you cannot select any LMI options).
• Choose Circuit type in the Link Configuration menu
to display a sub-menu of circuit types.
• Select the circuit type. On exiting the sub-menu your
selection is displayed.
The circuit types are as follows :
SVC
PVC
SVC & PVC
None
2
Note
If the Circuit type is set to SVC & PVC, and the SVC
protocol is Q933B, the SVC protocol defaults to FRF4.

PVC Configuration

If you have set Circuit type to either PVC or SVC & PVC,
you can set up parameters for permanent virtual circuits
(PVCs) from the Link Configuration menu.

Setting the LMI Protocol

• Choose LMI Protocol to display a protocols sub-menu.
The options available depend on the Interface type
you have selected. Select from the following options :
Annex A
Annex D
Gang-of-4
Issue 1a - 10/99
Frame Relay Testing - Section 1
Switched Virtual Circuit
Permanent Virtual Circuit
Both Switched and Permanent Virtual
Circuits
No circuits
Q.933 Annex A (ITU-T)
T1.617 (ANSI)
Defined by the gang-0f-4 consortium
(Northern Telecom, Digital Equipment
Corporation, StrataCom and Cisco)
5-5