Connect Tamper Switch To Main Board; Connect Tamper Switch To Expansion Board; Connect The Battery Leads To The Power Supply - Brivo ACS6000 Installation Manual

a) The tamper header connects to the supplied tamper switch.
b) The header connector for the tamper switch should be connected to the TAMPER pins
located on the lower right side of the MAIN BOARD and each expansion board.
2. Connect the tamper switch to one expansion board (DOOR BOARD or INPUT OUTPUT BOARD) in
each expansion chassis.
NOTE: If a chassis has two boards, connect the tamper switch to the upper board.
NOTE: If the tamper switch is not going to be used, leave the supplied jumper on
this connector to keep the circuit closed.

Connect the battery leads to the power supply

WARNING: Backup Battery
DO NOT CONNECT THE BACK-UP BATTERY AT THIS TIME. Premature connection of
the battery terminals may cause damage to the control panel.
© 2017 Brivo Systems LLC. All rights reserved.
Figure 6 - Connect Tamper Switch to MAIN BOARD
Figure 7 - Connect Tamper Switch to Expansion Board
19
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual