Acs6000 Wet/Dry Door Contact Switches For Doors 1 And 2 - Brivo ACS6000 Installation Manual

NOTE: Door lock relays can be provided with power by using Door 1 Wet/Dry
Switch above Door Node 1 and Door 2 Wet/Dry Switch above Door Node 2.
To enable wet mode for Door 1, put the Door 1 Wet/Dry Select Switch in the Wet
position. To enable wet mode for Door 2, put the Door 2 Wet/Dry Select Switch in
the Wet position.
To enable dry mode for Door 1, put the Door 1 Wet/Dry Select Switch in the Dry
position. To enable dry mode for Door 2, put the Door 2 Wet/Dry Select Switch in
the Dry position.
Figure 18 - ACS6000 Wet/Dry Door Contact Switches for Doors 1 and 2
NOTE: Refer to the Reader/Keypad Wiring Guide for Brivo approved devices and
connection diagrams.
a) Use the wire recommended by the manufacturer of the reader or keypad. If no wire is
recommended, use a minimum of 22 AWG wire with sufficient conductors that include
shield (drain).
b) If your reader interface uses standard Wiegand conventions, connect the wire properly
to the terminal block on the appropriate board node. Following is a typical, but not
universal, wiring guide. Refer to the Reader/Keypad Wiring Guide for guidelines related
to your specific reader or keypad.
© 2017 Brivo Systems LLC. All rights reserved.
Connect the green reader wire to the DATA0 terminal. This is the standard
•
Data 0 circuit for Wiegand readers.
• Connect the white reader wire to the DATA1 terminal. This is the standard
Data 1 circuit for Wiegand readers.
• Connect the black reader wire to the GND terminal. This is the standard
Ground circuit for the reader.
30
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual