Brivo ACS6000 Installation Manual page 16

Switch Setting Description
SW 7-1 Tamper
SW 7-2 CAN Bus
SW 7-3
SW 7-4 Maintenance Mode
SW 7-5
Factory Reset
SW 7-6
SW 7-7
SW 7-8 Wi-Fi
© 2017 Brivo Systems LLC. All rights reserved.
Functionality Description
Enabled: Tamper functionality is in use
Disabled: Tamper functionality is not in use
Enabled: CAN Bus is terminated
Disabled: CAN Bus is not terminated
For general operation, SW 7-4 needs to be in the Off position.
How to perform factory reset:
Ensure that SW 7-6 is in the OFF position.
•
Power off MAIN BOARD.
•
Place SW 7-6 dip switch in the ON position
•
Power on the board and wait until you hear two two-second
•
long beeps and see the main heartbeat LED turn off.
Within 10 seconds of hearing the beeps, place SW 7-6 dip
•
switch back into the OFF position.
You will hear a one second-long beep and the main
•
heartbeat LED will start blinking again indicating the system
is performing a factory reset.
• After the factory reset is complete, you will hear 2 short
beeps.
• At this point, the factory reset is complete the system will
now run with factory default firmware.
Enabled: Wi-Fi can be used if configured.
Disabled: Wi-Fi cannot be used at all, even if configured.
16
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual