Install Movs; Wire Doors For Osdp Readers Using Rs-485 - Brivo ACS6000 Installation Manual

7. Install MOVs.

WARNING: Noise Suppression
INSTALL THE TRANSIENT NOISE SUPPRESSION DEVICE (MOV) SUPPLIED WITH THE
CONTROL PANEL.
a) Install the MOV across the conductors, as close as possible to the electric strike or latch.
This will normally be at the connection from the field-installed wiring to the pig tail or
screw terminals of the electronic strike or latch.
b) Use the wire recommended by the manufacturer of the electric strike or latch. If no wire
is recommended, use a minimum of 18 AWG wire with sufficient strands for the specific
electronic strike or latch.
© 2017 Brivo Systems LLC. All rights reserved.
Figure 19 - Wire Doors for OSDP Readers using RS-485
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual
32