General Assembly Procedures; Assemble And Mount Chassis - Brivo ACS6000 Installation Manual

General Assembly Procedures

Assemble and mount chassis.

1. Stick the identity label to the inside of the metal chassis.
2. Install the supplied nylon stand-offs into each chassis by inserting them from the rear.
NOTE: This step MUST be performed before the chassis is mounted to the wall.
Once the chassis has been mounted, it is not possible to insert the stand-offs.
a) For the MAIN BOARD, there are 5 standoffs and 1 screw for the ground post, but there
are more holes than that in the chassis.
b) For DOOR BOARDs and INPUT OUTPUT BOARDs, there are five stand-offs for each
board, but there are more holes than that in the chassis.
c) Determine which holes you will use based on the size of the boards you are installing.
3. Mount the chassis.
a) Use four bolts to mount each chassis securely in place.
b) Make sure the chassis door can swing open freely to allow for access after the
installation is complete.
c) In tight spaces, the removable hinge design of the ACS6000/ACS6008 enclosures allow
an installer to completely remove the chassis door and replace it just as easily upon
completion of the installation.
4. Remove any knock-outs that may be required to accommodate conduit or wiring.
WARNING: Knockouts
DO NOT ATTEMPT TO REMOVE THE KNOCKOUTS WITH A HAMMER. Banging on
the knockouts may result in shock to the circuit boards, which could cause
permanent damage. Pry them out using a screwdriver.
5. Assemble the chassis.
a) Install the power supply board in each chassis first. If you install the MAIN BOARD or a
Door or INPUT OUTPUT BOARD first, you may find it difficult to position your
screwdriver in a way that will allow you to install the power supply board later.
b) Install the MAIN BOARD in the control chassis.
c) If there is a DOOR BOARD or an INPUT OUTPUT BOARD for the control chassis, install
that now, using the procedures described for the MAIN BOARD.
© 2017 Brivo Systems LLC. All rights reserved.
• Install each board by aligning it with the previously installed stand-offs and
then gently pressing it into place. You will hear a slight click as the board
settles into the locked position on the standoffs.
• After that, screw on the ground post screw on the bottom left corner.
13
Brivo ACS6000 Installation Manual
P-MAN-PUB-ACS6000 Installation Manual