Connect Tamper Switch To Main Board; Connect Tamper Switch To Expansion Board - Brivo ACS5000 Installation Manual

ACS5000 Installation Manual
Connect the AC Power Indicator LED for each chassis to the power supply for that
chassis.
1. Mount the AC power indicated LED on the front door of the chassis by pushing it through the
hold in the upper left corner of the door and securing using the bolt and washer included with
your packaging.
2. Connect the white and green wires from the AC power indicated LED to the 16.5 VAC
terminals of the power supply board.
Connect the tamper switch to the MAIN BOARD and to one board in each expansion
chassis.
1. Connect the tamper switch to the MAIN BOARD in the control chassis.
a) The tamper header connects to the supplied tamper switch.
b) The header connector for the tamper switch should be connected to the TAMPER
2. Connect the tamper switch to one expansion board (DOOR BOARD or INPUT OUTPUT BOARD)
in each expansion chassis.
© 2017 Brivo Systems LLC. All rights reserved.
WARNING: Powering Electronic Strikes and Latches
DO NOT POWER ELECTRONIC STRIKES AND LATCHES WITH THE BATTERY (OR
OTHER POWER SOURCE) USED TO POWER THE CONTROL PANEL; DOING SO
WILL CAUSE DAMAGE TO THE BRIVO CONTROL PANEL. USE ONLY A UL LISTED
BURGLAR ALARM OR ACCESS CONTROL SYSTEM TO POWER ELECTRONIC
STRIKES AND LATCHES.
Figure 3.

Connect Tamper Switch to MAIN BOARD

pins located on the lower right side of the MAIN BOARD and each expansion board.
Figure 4.

Connect Tamper Switch to Expansion Board

NOTE: If a chassis has two or more boards, connect the tamper switch to the upper
board.
Page 15
Rev 1