Torque Adjustment - Deprag 386365 A Operating Instructions Manual

4.2. Torque Adjustment

To avoid a driver lockout by the Multi-Function Controller, apply the following
adjustment method:
• input required amount of screws per part on the digital counter (field 3) to
the value of 97.
• turn key-switch to the reset-position or keep holding the reset-button.
While the driver is rotating, its function will be indicated as an error on the
Multi-Function Controller. For the torque-adjustment, disregard this error
indication. The driver is now ready for torque-adjustment:
For an external torque adjustment use the following steps:
1. Disconnect driver from air supply.
2. Insert the provided torque-adjustment screwdriver 326240 through the
slot on the clutch bearing into the oval bore-hole in the lock ring (if nec-
essary turn bit by hand).
3. By turning the torque-adjustment screwdriver 326240 clockwise, the
torque is reduced and if turned counter-clockwise, the torque is in-
creased.
Picture: Torque Adjustment
15