Operation - Deprag 386365 A Operating Instructions Manual

Recommended Accessories
Balancer, spring loaded
W C
EIGHT APACITY
–
FROM TO KG
0 – 0,5
0,3 – 1,2
1 – 2
2 – 3
4

Operation

This design of Screwdriver may only be operated in connection with the
DEPRAG-Function Controller pc10 and fc10.
ATTENTION:
The turning bit may cause an injury to fingers or hands.
When connecting the driver directly to an air-supply, the driver
will start immediately, since there is no integrated valve in the
tool!
Unless otherwise requested the driver is preset to max. torque with the
strongest clutch spring installed on the clutch. Adjust clutch to the required
torque value. If necessary, exchange clutch spring. The required torque
adjustment can be checked, using a DEPRAG Torque Wrench or
Dynamometer (see DEPRAG catalogs D3020 and D 3022). This equipment
can also be used to re-adjust the torque of the Screwdriver.
To operate the clutch, using a clutch spring which either
surpasses or falls below its specified torque range, leads to a
reduction of the torque accuracy.
The screwdriver starts with an e x t e r n a l v a l v e (integrated in the control).
Air flow pressure should be 90 PSI.
. C L
MAX ORD ENGTH
M
1,6
1,6
1,6
2
12
W P
EIGHT
kg
0,5 827676 A
0,5 827677 A
0,5 827678 A
1,2 808690 A
-N .
ART O