Adjusting The Top-Of-Form Threshold - QuickLabel Kiaro! 50 User Manual

Kiaro! 50 User Guide

Adjusting the Top-of-Form Threshold

If any of the following errors occur while using reflective mark media, you may need to
calibrate the top-of-form sensor threshold. The following table describes the types of
adjustments needed for each error condition.
Error #
5002 No paper
5103 Paper length difference
5105 Paper length difference
5305 Gap/Mark length
5404 Paper jam
5401 Paper jam
5402 Paper jam
Note: Before adjusting the top-of-form threshold, verify that your media has been
loaded and configured correctly.
If you have already adjusted the top-of-form threshold for your reflective mark media,
and you are replacing a reflective mark media roll with an identical roll, repeating this
adjustment is not necessary.
1 Launch the Kiaro! 50 Maintenance Utility.
From the Windows Start Menu, choose
Kiaro! 50 > Kiaro! 50 Maintenance
open.
Select a display language and the Kiaro! 50 printer you want to connect to. Choose
OK.
2 Choose the Adjustments
3 Choose Threshold
4 To read the internal sensor value from the printer and set the
control accordingly, choose
Error Name
Start > All Programs > QuickLabel
Utility. A language and printer prompt will
tab.
Adjustment. The Threshold Adjustment window will open.
Read From Printer.
Kiaro! 50 Maintenance Utility
Internal
Sensor Adjustment
Adjustment Value
Increase +0.1V
Increase +0.1V
Increase +0.1V
Increase +0.1V
Increase +0.1V
Decrease -0.1V
Decrease -0.1V
Internal Sensor
69