Table of Contents
Advertisement
Designing and Printing Labels
Using the Status Monitor
44
Note: Do not pull the printed labels in any direction as they exit the printer. Pulling
the labels may result in a media jam.
•
If
Cutter Enabled
will automatically be cut at the end of the job.
•
If
Cutter Enabled
labels will not be cut at the end of the job. Instead, you can use the manual cut
feature by pressing and holding the Pause key for at least two seconds.
Related Topics:
- Setting up Layout Options on page 41
- Operating the Manual Cut on page 55
Viewing the Printer Status
1
Open the Kiaro! 50 Status Monitor. You can access the Status Monitor from the
Windows Start Menu, Kiaro! 50 Maintenance Utility, or the printer driver.
•
From the Windows Start Menu, choose
Kiaro! 50 > Kiaro! 50 Status
•
In the Kiaro! 50 Maintenance Utility, choose
•
In the Kiaro! 50 printer driver printing preferences, choose
from the
Status
2
You can view status information in the Printer Status area. This area will display
informational, error, and warning messages related to your printer's current status.
3
If necessary, you can initiate printhead cleaning if the printer is in the Ready,
Sleeping, or Paused modes.
Three cleaning options are available (light, medium, and heavy). Start with light
cleaning and then print a test label. If the issue is not resolved, repeat using the
is checked in the printer driver
is not checked in the printer driver
Start > All Programs > QuickLabel
Monitor.
tab.
Layout
tab, the printed labels
Layout
tab, the printed
Status
Monitor.
Status Monitor
Kiaro! 50 User Guide
Advertisement
Table of Contents
