Lucent Technologies MLS-model Programming And Use Manual page 273

Hunt Group Extensions (#505)
To assign extensions to a Hunt Group:
1. Press
10 or 11.
2. At the Group: prompt, enter a group number (1–8). For example, to select
group 1, press
Hunt Group 1
Extension:
3. Enter the desired extension number. For example, to select extension 31,
press
4. To assign or unassign the extension, press
value displays.
5. At this point:
6. Select another procedure or exit programming mode.
f 0 0 s s # 5 0 5
1
. A display similar to the following appears:
3 1
.
To assign or unassign another extension, press
until the extension number shows on the display. Repeat Step 4.
To program another group, press
new group number, and repeat Steps 3 and 4.
at extension
D
until the appropriate
n
or
N P
p
, enter a
5-163