Lucent Technologies MLS-model Programming And Use Manual page 118

Feature Reference
Account codes can be changed during a call. However, only the person
who entered the original account code can enter a different account code.
SMDR prints changed account codes as follows:
— For optional or forced account code entry without a Forced Account
— For forced account code entry with a Forced Account Code List, the
If a Forced Account Code List exists, you can check to see if an account
code is valid when entering or changing an account code by pressing
f 1 2
valid, you will hear a denial tone.
The Lucent Technologies Call Accounting Terminal uses less than 16 digits
for an account code. Refer to the device's documentation to determine the
maximum digits supported.
You can program the Account Code Entry feature code on a button on a
system phone. It is recommended that you use a button with lights. (This
button can be used for optional Account Code Entry or Forced Account
Code Entry.)
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To program an Account Code Entry button:
1. Press
10 or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button, preferably one with lights.
4. Press
5. Program another button for this extension or exit programming mode.
Using
To enter or change an optional account code:
1. From a system phone, if a password is programmed for the system, you
must enter it before lifting the handset. [See System Password (#403) for
more information.]
2. After lifting the handset (or while already active on an outside call), press
the programmed Account Code Entry button or press
If the Account Code Entry button has lights, the green light turns on.
3. Enter an account code using one of the following methods:
5-8
Code List, the call report prints the last account code entered.
call report prints the last valid account code entered. If the changed
account code is not valid, the report prints the original account code.
after entering the account code. If the account code is not
e
and on system phones.)
f 0 0 s s c
f 1 2
.
Dial it manually using the phone's dialpad.
at extension
f 1 2
.