Lucent Technologies MLS-model Programming And Use Manual page 321

Personal Speed Dial Numbers
Valid Entries
Any phone number—up to 28 characters consisting of the digits 0–9,
special dialing functions that you can access by pressing
S
(Stop),
through 99.
No number assigned to any code
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To program Personal Speed Dial numbers:
1. Press
10 or 11.
2. Dial the number of the extension to be programmed with this feature.
3. Select a two-digit code by pressing
80 and 99. For example, to select code 81, press
If a number is assigned already to the code, the number appears on the
display. If no number is assigned to the code, the display reads:
Blank
4. Enter the phone number exactly as you would dial it.
5. At this point:
6. Continue programming or exit programming mode.
Using
System Phone
You can lift the handset or press
1. If you want to call on a specific line, press the line button (or press
8
and the two-digit line number) or if you want to call using a specific pool,
press the pool button (or press
code).
2. Press
&
(Recall), and (Touch-Tone Enable)—assigned to codes 80
e
and on system phones.)
f 0 0 s s c
To program another Personal Speed Dial number, start from Step 3.
To program over an existing number, enter the new number after
selecting the two-digit code.
To remove a Personal Speed Dial number, enter the number's
two-digit code and press
S
f
.
h
f
and dialing two digits between
f 8 1
!
once.
before dialing:
i
and the three-digit pool access
* #
, , and
!
(Pause),
at extension
.
i
5-211