Lucent Technologies MLS-model Programming And Use Manual page 181

Caller ID Call Log Line Association (#318)—Release 2.0
or Later
Valid Entries
1 = Assigned (line is associated with an extension or the extension is
associated with a line)
2 = Not assigned (line is not associated with an extension)
Programming
(See Figure 2-3 on page 2-22 for the location of special programming buttons such
s
as
To associate a line with an extension for the purpose of logging caller ID
information:
1. Press
10 or 11.
2. At the extension prompt, enter the number of the extension to be
programmed. For example, to program extension 23, press
3. At the Line prompt, enter the line number to be associated with the
extension. For example, to associate line 2 with the extension, press
4. To change the line association for this extension, press
appropriate value displays. (See "Valid Entries.")
5. At this point:
6. Select another procedure or exit programming mode.
e
and on system phones.)
f 0 0 s s # 3 1 8
To associate another line with this extension, press
p
until the line number shows on the display. Then repeat
Step 4.
To associate another extension, press
and begin at Step 2.
at extension
2 3
.
0 2
D
until the
n
or
N P
or
.
5-71