Table of Contents
Advertisement
The following table describes the LED operation.
OBD
The OBD LED will flash at a fast rate when the unit is first connected to the OBD port for power. Once a
(Red)
protocol is discovered through the OBD port, the LED will flash at a slow rate.
GPS
The GPS LED will flash at a fast rate when the unit is acquiring a satellite fix. Once a fix is acquired, the LED will
(Yellow/Amber)
flash at a slow rate.
NETWORK
The NETWORK LED will flash at a fast rate when the unit is finding cellular coverage. Once cellular coverage is
(Green)
found, the LED will flash at a slow rate.
Power
The MT 3060 requires 9-16 VDC minimum 2 amps input power. Pin 16 on the 16-Pin I/O
connector is the positive power input, and pins 4 and 5 are ground. This device contains a
battery. This battery is not to be removed or replaced by the user. Please dispose of this
device according to local recycling laws.
Accelerometer
The three-axis digital accelerometer provides the following features:
Figure 2-2 MT 3060 LEDs
MT 3060 LEDs
Table 2-1 MT 3060 LEDs
- 10 -
Hide quick links:
Advertisement
Table of Contents
