Sprint Activation; Device Installation - Novatel RTT2211 User Manual

Sprint Activation:

To activate with Sprint, the user must contact Sprint and provide the MEID of the device.
After the MEID is provided to Sprint, the user will need to power on the device when
instructed by the carrier. The device will automatically activate when it attaches to the
network. For the first attempt the user should see a series of unsolicited reports. If the device
gets to +HFA: 6, the device has successfully activated. This process can take up to 60 seconds
to complete. AT+HFA? can be used to query the activation state. A response of 1 means the
device is successfully activated. A response of 0 means that it has not.
An unsuccessful activation attempt may take up to 5 minutes, because of the number of
retries specified by the carrier.
As part of the activation process, the network will download a new PRL. The device will reset
after the PRL is successfully reset to allow the new PRL to take effect.

Device Installation

Make sure the vehicle is parked on level ground prior to installing the MT 3060.
Instructions provided in this section describe the hardware installation of the MT 3060
device. To install the MT 3060 in a vehicle, follow these steps:
1. Locate the OBDII socket. The location will vary between different vehicle manufacturers,
models, and production years.
2. Carefully insert the MT 3060 into the OBDII socket.
3. After the device is installed, the GPS lock and the cellular connection LEDs will validate
that the device is working properly.
The MT 3060 is NOT a waterproof or sealed device. Keep the device away from
water or any other liquids.
- 22 -