Table of Contents
Advertisement
Saia-Burgess Controls AG
Configuring the hardware settings in PG5 (PCD7.D443WT5Rx)
Generally speaking, the PCD7.D443WT5Rx is configured via PG5 in which the project too is cre-
ated. However, it can also be carried out on the panel itself via the Setup Menu described in Chap-
ter 4.
3.2.1
General
The following description assumes that you are familiar with the PG5 software. If not, it is recom-
mended that you read Manual 26/732 " User Manual PG5 21 ": The device configurator defines di-
rect access to programming instructions in order to read out values from the peripheral input module
and write values to the peripheral output module.
Downloading the program and backup (PCD7.D443WT5Rx)
The user program and the device configuration are loaded onto the panel with the PG5 software.
This is described below.
3.3.1
Backing up and restoring the user program
Backing up with PG5
Enable the backup with "Backup to Flash..."
Because the user program is already backed up in the on-board flash memory, only RAM DB/texts of
the on-board flash memory will be backed up (not visible to the user)
Note: Registers, flags, timers and counters will not be backed up.
If the system is restored, DB/text will be copied to the SRAM memory again.
Backup to INTFLASH file system
The RAM DB/text values will be backed up in the internal PCD_Backup folder. The backup files can
be accessed via the FTP server and uploaded to a PC.
PCD7.D443WTxRx | Document 27-644 | Version ENG04 | 2017-10-30
19
Advertisement
Table of Contents
