Technical Data For The Two Panel Types; Status Display, Sensors And Actions - SBC D443WTPR Manual

Saia-Burgess Controls AG
2

Technical data for the two panel types

Because of the programmable logic controller in the programmable panels, the hardware of the
PCD7.D443WTPR and PCD7.D443WT5R Micro Browser Panels differs in certain respects. These
differences are described in the following sections.

Status display, sensors and actions

Reset button
In run:
Button is pressed for longer than
45 sec during operation.
When starting up:
Button is pressed for longer than
45 sec before the power supply
(24V DC) is connected.
When starting up:
Button is pressed for longer than
90 sec before the power supply
(24V DC) is connected. Device re-
set to default factory settings
LED
Important:
Status display
See also Chapter 3.2 / 7.6
Temperature sensor
Accuracy +/- 1°C
Temperature range:
Note installation location "1.5.1"
Sensor must be calibrated
See also Chapter 7.6
PCD7.D443WTxRx | Document 27-644 | Version ENG04 | 2017-10-30
PCD7.D443WTPRx
Not available (x)
Not available (x)
Device reset to default factory set-
tings, the local INTFLASH and
PLC_SYS file systems will be for-
matted.
Hardware version "< B". Supports the colour green only
Hardware version ">= B". Supports the colours red, green and orange
During the boot process, the LED shows the operating status of the
panel. The LED will go out once the LCD has started successfully.
Yes
0°C to 40°C
Hardware version >= B
FW version >= 1.28.04
PCD7.D443WT5Rx
Program restore will be triggered.
Program restore will be triggered.
Device reset to default factory set-
tings, the local INTFLASH and
PLC_SYS file systems will be for-
matted. User program will be de-
leted.
Yes
0°C to 40°C
Hardware version >= B
FW version >= 1.28.04
16