Management Ports And Indicator Leds - Siemens RUGGEDCOM RSG2488 Installation Manual

Chapter 1
Introduction
• Supports Siemens FastConnect RJ45 Cabling System
• -40 to 85 °C (-40 to 185 °F) operating temperature (fanless)
• Conformal coated printed circuit boards (optional)
Section 1.2

Management Ports and Indicator LEDs

The RSG2488 features various ports and indicator LEDs on the front panel for configuring and troubleshooting
the device.
1
Figure 1: Front Panel
1. Power Module Indicator LEDs
6. Port Status Indicator LEDs
RS232 Serial Console Port
Management Port
Alarm Indicator LED
Power Module Indicator LEDs
Port Status Indicator LEDs
MicroSD Port
2
1
2. RS232 Serial Console Port
This port is for interfacing directly with the device and accessing initial management
functions.
This 10/100Base-T Ethernet port is used for system management that is out-of-band from
the switch fabric.
The alarm indicator LED illuminates when an alarm condition exists.
These LEDs indicate the status of the power modules. The top LED indicates the power
supply is supplying power. The bottom LED indicates the power supply is receiving power.
These LEDs indicate when ports are active.
This port houses the microSD card that may optionally contain the firmware and
configuration for the device.
2 3
3. Management Port 4. Alarm Indicator LED
Management Ports and Indicator LEDs
RUGGEDCOM RSG2488
Installation Guide
4
5
5. MicroSD Port
6