Table of Contents
Advertisement
Configuring the Network Services
Initial IP
Configuration
Installing the
MGC Manager
Starting the MGC
Manager
Defining an MCU
Connecting
to an MCU
Configuring the
Network Services
If no Network Services have been configured, depending on your system
configuration, an appropriate Network Configuration dialog box is
automatically displayed.
•
If your system is configured to work with both IP and ISDN, the Network
Configuration Wizard dialog box is displayed. This section describes the
configuration of both IP and ISDN Network Services.
If your system is configured to work with IP only, the IP Configuration
•
dialog box is displayed. For details, see page 3-10.
If your system is configured to work with ISDN only, the ISDN
•
Configuration dialog box is displayed. For details, see "To configure an
ISDN Network Service:" on page 3-13.
Network Configuration Wizard
The Network Configuration Wizard enables you to set up the ISDN and IP
network services quickly.
For information about defining T1-CAS Network Services, defining
additional ISDN or IP Network Services, adding advanced definitions or
modifying existing Network Services, refer to the MGC Administrator's
Guide, Chapter 3.
You can access the Network Configuration Wizard any time from the MCU
right-click menu.
Chapter 3 - Initial System Setup
3-9
Advertisement
Table of Contents
