Optimization; Ethernet Switch; Application Network Setup; Rtp Ports - Polycom Version 1.4.x 17 Administrator's Manual

Sip 1.4.0 soundpoint/soundstation ip sip
Table of Contents

Advertisement

Administrator Guide - SoundPoint

4 Optimization

4.1 Ethernet Switch

The SoundPoint
embedded Ethernet switch that runs at full line-rate. The Ethernet switch allows a per-
sonal computer and other Ethernet devices to connect to the office LAN by daisy
chaining through the phone, eliminating the need for a stand-alone hub. The
SoundPoint
phone. SoundPoint
powered (power supplied via the signaling or idle pairs of the LAN Ethernet cable).
Line powering typically requires that the phone plugs directly into a dedicated LAN
jack. Devices that do not require LAN power can then plug into the SoundPoint
PC Ethernet port.
SoundPoint
To help ensure good voice quality, the Ethernet switch embedded in the
SoundPoint
phone higher transmit priority than those from a device connected to the PC port. If
not using a VLAN (VLAN blank in the setup menu), this will automatically be the
case. If using a VLAN, ensure that the 802.1p priorities for both default and RTP
packet types are set to 2 or greater. Otherwise, these packets will compete equally
with those from the PC port. For more information, see 4.6.1.7 Quality of Service
<QOS/> on page 86.

4.2 Application Network Setup

4.2.1 RTP Ports

The phone is compatible with RFC 1889 - RTP: A Transport Protocol for Real-Time
Applications - and the updated RFCs 3550 and 3551. Consistent with RFC 1889, the
phone treats all RTP streams as bi-directional from a control perspective and expects
that both RTP endpoints will negotiate the respective destination IP addresses and
ports. This allows RTCP to operate correctly even with RTP media flowing in only a
single direction, or not at all. It also allows greater security: packets from unautho-
rized sources can be rejected.
®
®
IP / SoundStation
®
IP phones contain two Ethernet ports, labeled LAN and PC, and an
®
IP switch gives higher transmit priority to packets originating in the
®
IP can be powered via a local AC power adapter or can be line-
®
IP Switch - Port Priorities
®
IP phones should be configured to give voice traffic emanating from the
Copyright © 2004 Polycom, Inc.
IP
Optimization
®
IP
57

Advertisement

Table of Contents
loading

Table of Contents