Temperature Sensor - Fasel Elektronik FCU2000 Series Installation Instructions Manual

5.6.1

Temperature sensor

The following temperature sensor variants are available:
Installation site
Figure 6 : Installation site of oven sensor / bench sensor / combined bench sensor
Oven sensor for temperature
Bench sensor for temperature
Combined bench sensor for temperature and humidity
For all sensors
Limiter sensor for IR
Installation instructions Sauna control Series FCU2x00/FCU3x00/FCU4x00 / Version V 2.18
Oven sensor for temperature (FCU-SENSOR-OVEN-A)
Bench sensor for temperature (FCU-SENSOR-BENCH-A)
Combined bench sensor for temperature and humidity
(FCU-SENSOR-HUMIDITY-BENCH-A)
If the oven manufacturer has not specified any other position, the sensor should be
installed on the wall behind the sauna oven (middle of sauna oven) 20 cm below the
ceiling.
Install the bench sensor on the opposite side of the oven and 20 cm below the
ceiling or at shoulder height of the topmost bench. This position for the sensor is only
a recommendation for standard cabins.
Attention: The system installer has to consider cabin-specific conditions, such as
the position of the steam outlet, the supply and outlet air, the door (s), the shape of
the ceiling, etc., and mount the sensor at the appropriate place for this cabin!.
Install the combined sensor for temperature and humidity like the bench sensor.
Ensure unrestricted air circulation.
Do not install the sensors in the immediate vicinity of the door or a window.
The limiter sensor for the IR system is only required if the manufacturer of the IR
system a maximum temperature for their system dictates, which is smaller than our
room temperature of max. 70° C or limiter temperature of 130° C.
If a sensor is needed, it shall be installed according to specifications of the IR system
manufacturer.
Installation
19