Checks Before The Initial Commissioning; Switching On And Switching Off The Sauna Control - Fasel Elektronik FCU2000 Series Installation Instructions Manual

Commissioning
Improper
operation
Danger of fire
Health hazards
7.2

Checks before the initial commissioning

The following points should be checked before the initial commissioning:
7.3

Switching on and switching off the sauna control

Read the operating manual and the safety instructions thoroughly and follow them
before switching on.
→ See operating manual "Series FCU2x00/FCU3x00/4x00".
30
WARNING!
Improper operation can lead to serious injuries
Therefore:
– Read and follow the operating manual.
WARNING!
Danger of injury due to fire
Objects on the oven or near the oven can cause fire and thus lead to
injuries.
Therefore:
– Always keep the oven and its surrounding free of objects.
WARNING!
Danger of injury due to covering of the temperature sensor and/or
humidity sensor
Covering the temperature sensor and/or the humidity sensor can lead to
increased temperature and humidity. The increased values can lead to
health hazards or to serious injuries.
Therefore:
– Do not cover the temperature and humidity sensor.
– Ensure unrestricted air circulation.
Does the voltage supply match the specifications on the nameplate?
Have the cable specifications as per Table 1, page 9 and the electrical circuit
diagram Figure 17, page 28 been adhered to?
Is the control device connected as per the electrical circuit diagram?
Are the sensors (temperature and humidity) connected as per section 5.6, page 18
ff?
Have all the neutral conductors been laid on the N- bus bar in the sauna control
device?
Have all the earthing conductors been laid on the PE-bus bar in the sauna control
device?
Have all the screws been tightened correctly?
Installation instructions Sauna control Series FCU2x00/FCU3x00/FCU4x00 / Version V 2.18