Functional Test Of The Sensor - Fasel Elektronik FCU2000 Series Installation Instructions Manual

Commissioning
7.5

Functional test of the sensor

32
NOTE!
Operation of a gas oven:
The control device must be configured especially for the operation of a
gas oven.
It is possible to connect a gas burner (burner 1) to phase U and gas
burner (burner 2) to phase V. Phase W in this variant is meant for the
exhaust. Phase V for the burner 2 is switched off at a temperature
difference of 5 K below the set temperature.
The exhaust is active while the gas burner is heating.
* Moist operation is possible only with the corresponding optional
output.
NOTE!
Operation of a
The control device must be configured especially for the operation of a
thermal oil oven.
It is possible to connect a supply fan for heating to phase U and a
bypass to phase V. For both outputs is a control signal 0...10V
available.
NOTE!
– If the sensor or the sensors have not been properly connected then a
signal is sounded and an error message is displayed on the display.
→ See also operating manual "Series FCU2x00/
FCU3x00/FCU4x00".
Check the display of the temperature value. If required, compare the displayed value
with the value on a reference temperature measuring device. After approximately 10
minutes of operation the displayed temperature must increase significantly.
In case of the bathing option "Sauna with humidity" and a connected humidity
sensor, check the displayed value of the humidity sensor. If required, compare the
displayed value with the value on a reference humidity measuring device. After
approximately 10 minutes of operation of the evaporator, the displayed humidity
value must increase significantly.
If two temperature sensors (oven, bench or combined bench sensor) are connected,
then after 10 minutes of operation of the heating system, the temperature displayed
for the oven sensor should be higher than that of the bench sensor. If required,
change the connections in the sauna control.
Installation instructions Sauna control Series FCU2x00/FCU3x00/FCU4x00 / Version V 2.18
thermal oil oven: