Installation; Esd Protection; Installation Of Sauna Control Device Fcuxxxx; Installation Of The Operating Control Of Fcuxxxx-Design Und Fcuxxxx-Design-Glas - Fasel Elektronik FCU2000 Series Installation Instructions Manual

5

Installation

5.1

ESD protection

5.2

Installation of sauna control device FCUxxxx

Installation The sauna control device should be installed sideways, above and below at a distance
of at least 5 cm from the walls or other equipment. There should be a distance of 10 cm
between other electrical devices.
The control unit must be mounted so that it is at any time accessible! (e.g. for service,
wear parts, fuses, etc.)
5.3 Installation of the operating control of FCUxxxx-Design und FCUxxxx-
Design-Glas
Installation The operating control can be installed maximum 100 m away from the basic control
device.
Installation instructions Sauna control Series FCU2x00/FCU3x00/FCU4x00 / Version V 2.18
ATTENTION!
Note ESD protection!
Do not touch on electrical parts because of ESD protection reasons.
When assembling only touch the circuit board at the plastic case or at
the edge of the board.
Also only touch the connection cable to the circuit board, on the
connector. Thereby do not touch the contact surfaces.
Therefore:
Take appropriate protections. Touch a grounded piece of metal as a
minimum protection.
Note!
At FCUxxxx-Design-Glas the main switch of the control unit must be
accessible.
ATTENTION!
Damage or malfunction of the operating control FCUxxxx-Design-
Glas by steam, humidity or water!
Therefore:
It must be ensured, that neither steam, humiditiy or water can occur at
or in the keyboard.
Installation
15