Botex DMX DC-192 User Manual page 41

Deleting chase steps
6. Use the scene bank UP / DOWN buttons to select the scene bank that contains the scene
you want to add. You can see the scene bank in the display by looking at the digits on
the right outer side.
7. Press [Midi/Rec] to copy the step into your chase. When the step is added, all LEDs flash
three times.
8. Repeat steps 3 to 7 to add further chase steps.
9. Keep [Program] pressed for about two seconds or until the PROG indicator stops flashing
on the display. As soon as the blackout indicator flashes, the programme mode is deacti-
vated.
1. Keep [Program] pressed for about two seconds or until the PROG indicator flashes on the
display. When the indicator flashes, the recording mode is active and you can release the
button.
2. To select a chase press the corresponding [CHASE] button (1 to 12). The corresponding
LED lights up.
3. Press [Tap/Disp], step indicator lights up on the display.
4. Press the scene bank UP / DOWN buttons to move manually through each section of the
chase step. Locate the chase step you want to delete.
Operating
DMX DC-192
41
DMX controller