Botex DMX DC-192 User Manual page 33

8.3.2 Editing scenes
8. Keep [Program] pressed for about two seconds or until the PROG indicator stops flashing
on the display. As soon as the blackout indicator flashes, the programme mode is deacti-
vated.
1. Keep [Program] pressed for about two seconds or until the PROG indicator flashes on the
display. When the indicator flashes, the recording mode is active and you can release the
button.
2. Use the scene bank UP / DOWN buttons, select the scene bank that contains the scene
you want to edit. You can see the active scene bank in the display.
3.
Press the [SCENE] button (1 to 8) of the scene you want to edit.
4. Select the device or devices where you want to change the settings for each scene. To
do so, press the corresponding [FIXTURE] buttons (1 to 12). The LEDs of the selected
devices light up.
5. Use the faders or the joystick to adjust the settings.
6.
Press the button [Midi/Rec] and then the [SCENE] button of the scene you want to edit.
All LEDs flash three times when the new settings are saved.
Operating
DMX DC-192
33
DMX controller