Operating; Manual Operation; Joystick Settings - Botex DMX DC-192 User Manual

8

Operating

8.1 Manual operation

8.2 Joystick settings

Assigning the joystick
When you turn on the controller, it starts by default in Manual / Blackout mode. All output
values are blanked out. To show the values, press [Blackout]. To determine the respective
blackout status, there is an indicator in the display that flashes when activated and shows 'OFF'
when deactivated. To enable manual operation, turn off Blackout, select the devices to control
using the corresponding [FIXTURE] buttons on the left side. Then use the eight channel faders,
the joystick and [PAGE SELECT] to manually control the devices.
1.
Keep [Program] pressed for about two seconds or until the PROG indicator flashes on the
display. When the indicator flashes, the recording mode is active and you can release the
button.
2. Keep [MODE] pressed and press [FINE]. The LEDs for [ASSIGN] and [PAN] should light up
now.
Operating
DMX DC-192
27
DMX controller