Scenes - Botex DMX DC-192 User Manual

Operating

8.3 Scenes

8.3.1 Recording scenes
DMX DC-192
32
DMX controller
1. Keep [Program] pressed for about two seconds or until the PROG indicator flashes on the
display. When the indicator flashes, the recording mode is active and you can release the
button.
2.
Select the devices you want to incorporate into your scene. To do so, press the corre-
sponding [FIXTURE] buttons (1 to 12). The LEDs of the selected devices light up.
3. Design your scene using the eight channel faders, the joystick and [PAGE SELECT]. This
should be used to switch between channels 1 to 8 and 9 to 16.
4.
When you are satisfied with your scene, press [Midi/Rec] to record.
5. Use the scene bank UP / DOWN buttons, select a scene bank for the backup. A total of 30
scene banks are available. These can be seen in the display by looking at the digits on
the right outer side.
6. Press one of the [SCENE] buttons (1 to 8) to store. As soon as all the LEDs flash, the scene
is saved. Make sure you use a different button each time you save a scene so you do not
overwrite what you want to keep.
7.
To record additional scenes, repeat steps 2 to 6.