Subaru Impreza 2017 Owner's Manual page 213

3-74
Instruments and controls/Light control switch
beam to low beam (or vice versa). When
all of the following conditions are met, the
headlight will change to high beam.
. When the vehicle speed increases to
or above the preset level.
. There is no preceding vehicle.
. The forward area of the vehicle is dark.
When any of the following conditions is
met, the headlight will change to low
beam.
. When the vehicle speed decreases to
or below the preset level.
. When the forward area of the vehicle is
bright.
. When there is a preceding or oncoming
vehicle.
NOTE
. The preset vehicle speed varies
depending on the models.
. The factory setting (default setting)
for this function is set as "operational".
This setting can be changed to OFF
(non-operation) at SUBARU dealers.
For more details, we recommend that
you contact a SUBARU dealer.
! How to use the High Beam Assist
function
The High Beam Assist function will be
activated when all the following conditions
are met.
. The light control switch is in the
AUTO position and the low beam head-
lights are on automatically.
. The turn signal lever is pushed forward.
High Beam Assist indicator (green)
When the High Beam Assist function is
activated, the High Beam Assist indicator
(green) on the combination meter will
illuminate.
Malfunction of the High Beam Assist
function:
High Beam Assist warning indicator (yel-
low)
When the High Beam Assist function
malfunctions, the High Beam Assist warn-
ing indicator (yellow) on the combination
meter will appear. In this case, we
recommend that you have your vehicle
inspected by your SUBARU dealer.
Temporary stop of High Beam Assist
function:
If the High Beam Assist function stops
temporarily due to poor visibility or abnor-
mal temperature, the message appears
on the combination meter. When the
condition is canceled, the system will be
restored.