Subaru Impreza 2017 Owner's Manual page 183

3-44
Instruments and controls/Combination meter display (color LCD)
By operating the or
steering wheel, you can select the menu.
Pull the /SET switch to enter the
selected menu.
NOTE
If you enter the "Go Back" menu, the
system will return to the previous
screen.
! Screen Settings
After entering the Screen Settings menu,
select one of the following menus.
! Welcome Screen
The welcome screen can be activated or
deactivated.
! Good-bye Screen
The good-bye screen can be activated or
deactivated.
! Gauge Initial Movement
The movement of the meter needles and
gauge needles that occurs when the
ignition switch is turned to the ON
position can be activated or deactivated.
! Units
Changes the units displayed in the com-
bination meter display (color LCD), type A
multi-function display (black and white)
and type B multi-function display (color
switch on the LCD).
! Tire Pressure Units (if equipped)
Changes the units displayed in the Tire
Pressure Monitoring system.
! Languages
Changes the language displayed in the
combination meter display (color LCD)
and multi-function display (color LCD).
! Warning Volume (if equipped)
Sets the EyeSight warning volume and
SRVD warning volume.
! EyeSight (models with EyeSight
system)
NOTE
For models with the EyeSight system,
refer to the Owner's Manual supple-
ment for the EyeSight system.
After entering the EyeSight menu, select
one of the following menus.
! Lead Vehicle Acquisition Sound
When adaptive cruise control is used, the
buzzer that sounds if a vehicle is detected
in front or if detection is not possible can
be activated or deactivated.
! Lead Vehicle Moving Monitor
Function
When adaptive cruise control is used, the
buzzer that sounds if a vehicle in front has
started can be activated or deactivated.
! Cruise Control Acceleration
Characteristics
Adaptive Cruise Control acceleration char-
acteristics can be set in four steps.
! Vehicle Setting
After entering the Vehicle Setting menu,
select one of the following menus.
! Keyless Entry System
Sets the settings used when the keyless
access function was operated.
. Hazard Warning Flasher:
Sets the operation of the hazard warning
flasher that blinks when the door is locked
or unlocked.
. Security Relocking (if equipped):
The automatic locking operation period
can be set or customized. Select the
preferred seconds to customize the op-
eration period.
! Defogger
Sets and customizes the operation of the
defogger.