Eco Gauge (If Equipped); Combination Meter Settings - Subaru Impreza 2017 Owner's Manual

during braking, turning or acceleration due
to fuel level movement in the tank.
NOTE
. You will see the " " sign in the fuel
gauge. This indicates that the fuel filler
door (lid) is located on the right side of
the vehicle.
. If you press the TRIP RESET switch
while the ignition switch is in the
"LOCK"/"OFF" or "ACC" position, the
fuel gauge will light up and indicate the
amount of fuel remaining in the tank.
The indicators will turn off when:
. The TRIP RESET switch is not
operated for approximately 10 sec-
onds.
. The driver's door is opened and
then closed.
& ECO gauge (if equipped)
The ECO gauge shows the difference
between the current rate of fuel consump-
tion and the average rate of fuel consump-
tion since the trip meter was last reset.
If the ECO gauge moves towards the +
side, this indicates better fuel efficiency.
NOTE
. The ECO gauge shows only an
approximate indication of fuel effi-
ciency.
. After resetting the trip meter, the
average rate of fuel consumption is not
shown until you have driven for 1 km
(or 1 mile). Before that time, the ECO
gauge does not operate.
Instruments and controls/Meters and gauges
& Combination meter settings
Meter and vehicle settings can be set on
the combination meter.
! Type A combination meter
Various adjustments can be made, such
as switching units shown on the combina-
tion meter and adjusting the warning tone
volume.
While the ignition switch is in the OFF
position, each press of TRIP RESET
switch results in items shown in the table
below being switched.
Combination
Item
meter display
A trip
B trip
Gauge
needle
sweep
function
Changing
the unit*
Warning
volume*
*: if available
3-11
Possible
settings
On/Off
mile/km
Lv. 1/Lv. 2/Lv. 3
– CONTINUED –