Automatic (Square) Buttonhole; Thread Tension; E R R Foot Pressure - Janome Memory Craft 6700P Instruction Book

q
z
q
x
q
w
e r
63

Automatic (square) Buttonhole

q Pattern:
w Presser foot:
e Thread tension:
r Foot pressure:
Pull the button holder all the way out.
Mark the buttonhole position on the fabric.
Place the fabric under the foot, and lower the needle at
the starting point.
Lower the foot and start sewing while pulling the needle
thread lightly to the left. After sewing a few stitches, free
the thread and continue sewing.
NOTE:
You do not need to pull down the buttonhole lever.
If you want to sew a buttonhole longer than the size
permitted by the automatic buttonhole foot R, use
satin stitch foot F.
NOTE:
The buttonhole width can be adjusted from 2.6 to 9.0.
The stitch density can be adjusted from 0.20 to 1.00.
z Sew the left side up to the required buttonhole length
and stop the machine. Then press the reverse key q.
x Start sewing again, and the machine sews back with
a straight stitch.
Stop the machine when you reach the starting point.
Then press the reverse key q.
MODE 2: 024
Automatic buttonhole foot R
1-5
3