!0
!0
!1
Setting the spool of thread or thread cone (special
size)
Use the spool holder (special) to hold the specific size of
the spool of threads as shown.
o
The sizes of the spools of thread are as follows;
The hole diameter of the spool has a range of 3/8˝ to
7/16˝ (9.5 to 10.5 mm)), and the spool length has a range
of 2 3/4˝ to 3˝ (70 to 75 mm).
o Spool holder (special)
!0 Hole diameter (3/8˝ to 7/16˝)
!1 Spool length (2 3/4˝ to 3˝)
Firmly insert the spool holder (special) into the hole and
hold the spool as illustrated.
Bobbin winding while working on a sewing project
There are 2 spool pins on the spool stand.
You can use both spool pins when you need to wind a
bobbin without unthreading the machine while working on
a sewing project.
Place a spool of thread on the spool pin and fix the spool
with the spool holder as shown.
NOTE:
Those spool pins are also used for twin needle sewing
(refer to page 80).
19