Winding The Bobbin - Janome Memory Craft 6700P Instruction Book

w
e
e
q
w
e
q
y
w
u
q
r
t t
r
r
i

Winding the Bobbin

Removing the bobbin
Slide the hook cover release button to the right, and
remove the hook cover plate.
q Hook cover release button
w Hook cover plate
Lift out the bobbin from the bobbin holder.
e Bobbin
NOTE:
Use the "J" plastic bobbins for horizontal hook (marked
with "J" r). Using other bobbins, such as pre-wound
paper bobbins, may cause stitching problems and/ or
damage to the bobbin holder.
Setting the spool of thread
Place the spool of thread on the spool pin with
the thread coming off the spool as shown.
Attach the spool holder, and press it firmly against the
spool of thread.
q Spool of thread
w Spool pin
e Large spool holder
Use the large spool holder for ordinary spools, while the
small spool holder for small spools.
r Small spool
t Small spool holder
NOTE:
Avoid using a paper cored spool when it begins to
empty since it will not unwind smoothly. It may cause
the thread to bunch or slip when using the auto thread
cutter.
Setting the thread cone
Use the spool rest and the spool net for thread cones.
Attach the spool rests on the spool pin.
Place the spool cone on the spool pin.
Cover the thread cone with the spool net if the thread is
shaky or kinky when sewing.
If the net is too long for a spool, fold the net and place it
on the spool.
w Spool pin
y Thread cone
u Spool rest
i Spool net
18