Janome Memory Craft 6700P Instruction Book page 61

c
v
u
!0 !0
o
b
y
i
!0
o o
c Draw the needle thread to the left through the hole of
the foot.
Mark the buttonhole position on the fabric and place
it under the buttonhole foot. Lower the needle at the
starting point by turning the handwheel.
y Starting point
v Lower the presser foot and pull the buttonhole lever
down as far as it will go.
u Buttonhole lever
NOTE:
Make sure there is no gap between the slider and
front stopper, otherwise the buttonhole will be out of
position or there will be a sewing gap.
i No gap
o Starting point
!0 Sewing gap
b Start sewing while pulling the needle thread lightly to
the left. After sewing a few stitches, free the thread
and continue sewing.
NOTE:
If you start sewing without pulling down the buttonhole
lever, the LCD screen will show a warning and
the machine will stop after a few stitches. Pull the
buttonhole lever down and start sewing.
59