B2 Automatic (Square) Buttonhole - Janome Continental M17 Instruction Book

z
q
x
q

B2 Automatic (square) Buttonhole

Pull the button holder all the way out.
Mark the buttonhole position on the fabric.
Place the fabric under the foot, and lower the needle at
the starting point.
Lower the foot and start sewing while pulling the needle
thread lightly to the left. After sewing a few stitches, free
the thread and continue sewing.
NOTE:
• You do not need to pull down the buttonhole lever.
• If you wish to sew a buttonhole longer than the size
permitted by automatic buttonhole foot R, use satin
stitch foot F.
NOTE:
• The opening idth can e adjusted rom
• The uttonho e idth can e adjusted rom
• The stitch densit can e adjusted rom
e the e t side up to the re uired uttonho e
z
length and stop the machine. Then press the reverse
button q.
x Start sewing again, and the machine sews back with
a straight stitch.
Stop the machine when you reach the starting point.
Then press the reverse button q.
68
to
to
to