Threading The Machine - Janome Memory Craft 6700P Instruction Book

z
w
q
v
b
v
y
n
i
e
x
t
r
c
b
u
!1
!0 o

Threading the Machine

CAUTION:
Always make sure to press the lockout key to lockout
the machine before threading the machine.
z Press the needle up/down key to raise the take-up
lever to the highest position.
Press the lockout key to lockout the machine.
q Needle up/down key
w Thread take-up lever
e Lockout key
x Pass the thread through the guide on the thread guide
bar from behind.
r Thread guide bar
c Pass the thread through the right thread guide.
t Right thread guide
v Hold the upper thread with both hands as shown
and slip it under the thread guide plate.
y Thread guide plate
b Draw the thread toward you and pass it into the left
thread guide.
u Left thread guide
n Draw the thread along the right channel, and around
the tension dial from the right to the left. Pull the
thread up to insert it between the tension disks and
under the loop of the check spring.
Be sure that the thread is coming out from notch of
the disk.
i Right channel
o Thread tension dial
!0 Check spring
!1 Notch
22