Configuring Logic Id Authentication - Cisco RV315W Administration Manual

System Management
Configuring TR-069
STEP 3
STEP 1
STEP 2
Cisco RV315W Broadband Wireless VPN Router Administration Guide
- Username: Enter the username of the remote management server in
order to send the connection requests to CPE.
- Password: Enter the password of the remote management server in
order to send the connection requests to CPE.
- Send Inform Packets: (Optional) Click Enable to enable the Send Inform
Packets feature, or click Disable to disable this feature.
- Send Interval: If you enable the Send Inform Packets feature, set the
interval in seconds to send the inform packets. The default value is 1800
seconds.
- Request Connection Port: Enter the port number used to request the
connection to TR-069.
- Download Request: (Optional) Specify the type of download request.
Select Firmware to send a request to download the firmware of the
RV315W to the TR-069 server, or select Vendor Configuration to send a
request to download the configuration file with the factory default
settings, then click OK to send the corresponding download request to
the TR-069 server.
- Upload Request: (Optional) Specify the type of upload request. Select
Configuration File to send a request to upload the current configuration
file of the RV315W to the TR-069 server, or select Vendor Configuration
to send a request to upload the configuration file with the factory default
settings of the RV315W to the TR-069 server. Then click OK to send the
corresponding upload request to the TR-069 server.
- Change Account Request: Click OK to send a request of changing the
administrative password to the TR-069 server.
Click OK to save your settings.

Configuring Logic ID Authentication

To configure Logic ID (LOID) Authentication:
Click System Management > TR-069 Settings > Logic ID Authentication. The
Logic ID Authentication page opens.
Enter the following information:
• Username: Enter the username for LOID authentication.
9
94