Configuring Wan1/Lan0 Interface - Cisco RV315W Administration Manual

Port Management
Configuring WAN Connections
STEP 6
STEP 7
STEP 8
STEP 1
STEP 2
STEP 3
!
CAUTION
Cisco RV315W Broadband Wireless VPN Router Administration Guide
• Interface: Name of the WAN interface.
• IP Address: IP address of the WAN interface.
• Subnet Mask: Subnet mask of the WAN interface.
• Gateway: Default gateway IP address of the WAN interface.
In the Load Balancing area, check Enable to enable Load Balancing to distribute
the bandwidth to two WAN ports by the weighted percentages.
In the Load Balancing Control area, specify the weighted percentage for each
WAN, such as 50% bandwidth for WAN0, 50% bandwidth for WAN1, and 0% for
USB_3G, which indicates that 50% bandwidth is distributed to WAN0 and 50%
bandwidth is distributed to WAN1. The value of zero (0) indicates that Load
Balancing is disabled on the 3G USB interface.
Click OK to apply your settings.

Configuring WAN1/LAN0 Interface

The WAN1/LAN0 port on the back panel of the RV315W can be configured to a
secondary WAN port (WAN1) or an additional LAN port (LAN0).
Click Port Settings > WAN > WAN1/LAN0 Interface Settings. The WAN1/LAN0
Interface Settings page opens.
Select LAN0 to set this port to an additional LAN port, or select WAN1 to set this
port to a secondary WAN port.
Click OK to apply your settings.
Changing the port type of the WAN1/LAN0 ports requires the RV315W to be
rebooted. Note that changing the port type from WAN1 to LAN0 will reboot the
RV315W with the factory default settings. The previous settings that you made on
the RV315W will be lost.
4
40