Table of Contents
Advertisement
20
www.electrolux.com
If the Pyrolysis function
operates, the door locks
automatically.
A message comes on in the
display when you touch any
symbol.
1. Touch
2. Touch
until the display shows a message.
To deactivate the Child Lock function
repeat step 2.
10.3 Function Lock
This function prevents an accidental
change of the heating function. You can
activate it only when the appliance
operates.
1. Activate the appliance.
2. Set a heating function or setting.
3. Press
display shows: Function Lock.
4. Press
If the Pyrolysis function
operates, the door is locked
and the symbol of a key
comes on in the display.
To deactivate the function, press
display shows a message. Press
and then
When you deactivate the
appliance, the function also
deactivates.
10.4 Set + Go
The function lets you set a heating
function (or a programme) and use it later
with one press of any symbol.
1. Activate the appliance.
2. Set a heating function.
3. Press
display shows: Duration.
4. Set the time.
5. Press
display shows: Set + Go.
6. Press
to activate the display.
and
at the same time
again and again until the
to confirm.
to confirm.
again and again until the
again and again until the
to confirm.
Press any symbol (except for
the function: Set + Go. The set heating
function starts.
When the heating function ends, an
acoustic signal sounds.
• Function Lock is on when
• The menu: Basic Settings
10.5 Automatic Switch-off
For safety reasons the appliance turns off
automatically after some time if a heating
function operates and you do not change
any settings.
Temperature (°C) Switch-off time
30 - 115
120 - 195
200 - 245
250 - maximum
. The
The Automatic switch-off
again
does not work with the
functions: Light, Food
Sensor, Duration, End Time.
10.6 Brightness of the display
There are two modes of display
brightness:
• Night brightness - when the appliance
is deactivated, the brightness of the
display is lower between 10 PM and 6
AM.
• Day brightness:
– when the appliance is activated.
– if you touch a symbol during the
night brightness (apart from ON /
OFF), the display goes back to the
day brightness mode for the next
10 seconds.
– if the appliance is deactivated and
you set the function: Minute
Minder. When the function ends,
the heating function
operates.
lets you activate and
deactivate the function:
Set + Go.
(h)
12.5
8.5
5.5
1.5
) to start
Advertisement
Table of Contents
