Installer Setting - Ventilator; Test Run Setting (Air Conditioner / Dx Venti- Lator) - LG PREMTB100 Owners & Installation Manual

INSTALLER SETTING
108

Installer setting - ventilator

• You can set the product user functions.
• Some functions may not be displayed/operated in some product types.
Menu Applied products
DX(Direct Ex- It is the function to set the trial operation at the initial
Test run setting
changer) Type product installation.
Central control address It is the function to set the central control address of
General
Setting the indoor unit during the central controller connection.
It is the function to set the fan speed value correspon-
Air supply ESP
ding to the air supply side fan speed.
General/DX Type
It is the function to set the fan speed value correspon-
Air discharge ESP
ding to the air discharge side fan speed.
It is the function to set the ventilation indoor unit's in-
Product direction General
stallation direction.
Express ventilation pri- It is the function to set the priority of the air supply and
ority discharge during the express ventilation operation.
General/DX Type
RMC master/slave set- It is the function to set group control or 2-remote con-
ting troller control.
The operation master / slave selection function is to
avoid other mode operations, and it is the function to
Override master/slave
DX Type prevent the selection of the opposite mode of the in-
setting
door unit set as master by the indoor units set as
slaves.
Dry contact function is the function that can be used
Dry contact mode set-
DX Type only when the dry contact devices is separately pur-
ting
chased and installed.
It is the function to set the indoor unit's fan speed op-
Fixed fan speed setting DX Type
tion to variable or fixed.
It is the function to set whether to use the humidifica-
Hum. Of Stand-alone
General/DX Type tion function in the direct cooling type ventilation's ven-
Vent. Mode
tilation single operation.
Hum. Of Vent. With It is the function to set the direct cooling type ventila-
DX Type
Heating Oper. tion's heating humidification function as auto or manual.
It is the function to increase/decrease ventilation's stan-
Vent. Fan Speed Align-
General dard fan speed from the current status according to the
ment
field environment.
Description
Test run setting (air conditioner / DX ventilator)
After product installation, the Test run must be performed. For Test run related details, refer to
the product manual.
• In the installer setting list, select the Test run setting category, and press [OK] button to move
to the detail screen.
- You can select 'cooling Test run / heating Test run'
- During the Test run, if you start the following functions, the Test run stops.
☞ Operation mode, desired temperature, fan speed, wind direction, start/stop
INSTALLER SETTING
OK
109