INSTALLATION INSTRUCTIONS
30
Installer Setting -How to enter installer setting mode
CAUTION
!
Installer setting mode is to set the detail function of the remote controller.
If the installer setting mode is not set correctly, it can cause problems to the product, user
injury or property damage. This must be set by an certificated installer, and any installation or
change that is carried out by a non-certificated person should be responsible for the results.
In this case, free service cannot be provided.
Refer to the Installer Setting Code Table on the next page.
1
With the JET COOL or Jet Mode button pressed, press the RESET
button.
or
2
By using the TEMPERATURE SETTING button, set function code and
setting value. (Please refer the Installer Setting Code Table.)
Function Code
Setting Code
3
Press the ON/OFF button toward the indoor unit 1 time.
4
Reset the remote controller to use the general operation mode.
JET
Mode