Air Conditioner And Ventilation Interface; Installer Setting; How To Enter Installer Setting - LG PREMTB100 Owners & Installation Manual

AIR CONDITIONER AND VENTILATION INTERFACE

104
AIR CONDITIONER AND VENTILATION IN-
TERFACE
• It controls using the wired remote controller at a place where the air conditioner indoor unit and
the ventilation product are connected and installed at the same time.
- When the power is applied, the remote controller recognizes the product and operates nor-
mally.
Independent operation
[general ventilation
independent operation]
General
General
ventilation
ventilation
Wired
remote
OK
controller
[Direct ventilation
independent operation]
General
Direct ventilation
ventilation
Wired
remote
controller
OK
※The wiring method is the same as the air conditioner user manual. (Refer to the remote con-
troller manual group control page contents)
※Ventilation product means general ventilation product and direct cooling type ventilation prod-
uct.
Interfaced operation
[General ventilation interfaced operation]
General
Air conditioner
ventilation
indoor unit
Wired
remote
controller
OK
[Direct ventilation interfaced operation]
General
Air conditioner
ventilation
indoor unit
Wired
remote
controller
OK

INSTALLER SETTING

How to enter installer setting

CAUTION
!
The installer setting mode is the mode to set the remote controller's detail function. If the in-
staller setting mode is incorrectly set, it may cause product failure, user's injury, or property dam-
age. It must be set by the installation specialist with the installation license, and if it is installed or
changed without installation license, all problems caused will be the responsibility of the installer,
and may void the LG warrenty.
• In the menu screen, press [<,>(left/right)] button to select the setting category, and press
[∧(up)] button for 3 seconds to enter the password input screen for the installer setting.
• Input the password and press [OK] button to move to the installer setting list.
OK
※Installer setting password
Main screen → menu → setting → service → RMC version information → SW Version
Example) SW version : 1.00.1 a
In the above case, the password is 1001.
NOTE
!
Some categories of the installer setting menu may not be available depending on the prod-
uct function or the menu name may be different.
INSTALLER SETTING
105
OK