Lcd Display; General; Lcd Rotation; Retrofitting - Emerson Rosemount 3308 Reference Manual

Rosemount 3308

LCD DISPLAY

General

LCD Rotation

Figure 4-10. LCD Rotation

Retrofitting

Figure 4-11. LCD Display
Retrofit Kit

LCD Configuration

4-18
PRELIMINARY
NOTE!
Do not remove the instrument cover in explosive environments when the
circuit is live.
If the LCD display is ordered in the transmitter model number (option code
M5), it will be shipped attached to the transmitter.
NOTE
If ordering spare parts for a replacement LCD, only use Rosemount Wireless
LCD Part Number: 00753-9004-0002. This will provide a replacement
LCD/electronics board, and LCD pin connector.
The optional LCD display can be rotated in 90-degree increments by
squeezing the two black tabs on opposite sides of the display, gently pulling
out the display, rotating to the desired orientation, and snapping back the
display into place. Refer to Figure 4-10 for a graphical illustration.
If the LCD pins are inadvertently removed from the interface board, carefully
re-insert the pins before snapping the LCD display back into place.
If an existing transmitter with no display (flat electronics cover) is to be
retrofitted with a new display, order spare part number 00753-9004-0001. This
kit contains an extended aluminum cover with an LCD viewing window, an
LCD/electronics board, and an LCD pin connector. The contents of this kit are
shown in Figure 4-11.
LCD
Pins
LCD Display
To install the LCD display, remove the electronics-side flat cover. Insert the
four-pin connector into the LCD display, rotate the LCD to the desired
orientation, and gently snap into place. Replace the flat cover with the LCD
cover and tighten. Refer back to Figure 4-10 for a graphical illustration.
How to configure parameters displayed, update rate, always off, etc.
Reference Manual
00809-XXXX-4811, Rev AA
LCD
LCD Display
Pins
LCD Cover
February 2012
LCD Cover