Extend The Server From The Rack - HP ProLiant DL385p Maintenance And Service Manual

This method forces the server to enter standby mode without properly exiting applications and the
OS. If an application stops responding, you can use this method to force a shutdown.
•
Use a virtual power button selection through iLO.
This method initiates a controlled remote shutdown of applications and the OS before the server
enters standby mode.
Before proceeding, verify the server is in standby mode by observing that the system power LED is
amber.

Extend the server from the rack

Pull down the quick release levers on each side of the server.
1.
Extend the server from the rack.
2.
WARNING: To reduce the risk of personal injury or equipment damage, be sure that the rack
is adequately stabilized before extending a component from the rack.
After performing the installation or maintenance procedure, slide the server back into the rack, and
3.
then press the server firmly into the rack to secure it in place.
WARNING: To reduce the risk of personal injury, be careful when pressing the server
rail-release latches and sliding the server into the rack. The sliding rails could pinch your
fingers.
Removal and replacement procedures 26