System Board - HP ProLiant DL385p Maintenance And Service Manual

Remove the battery.
7.
To replace the component, reverse the removal procedure.
For more information about battery replacement or proper disposal, contact an authorized reseller or an
authorized service provider.

System board

To remove the component:
Power down the server (on page 25).
1.
Remove all power:
2.
Disconnect each power cord from the power source.
a.
Disconnect each power cord from the server.
b.
Remove the server from the rack (on page 27).
3.
Remove all power supplies
4.
Remove the access panel
5.
Remove the air baffle (on page 31).
6.
Remove the PCIe riser cage
7.
primary PCIe riser
If installed, remove the secondary PCIe riser cage (on page 34).
8.
If installed, remove the FBWC capacitor pack
9.
48).
If installed, remove the cache module
10.
Remove the FlexibleLOM ("FlexibleLOM" on page 42).
11.
Remove all DIMMs ("DIMMs" on page 61).
12.
Remove the fan cage
13.
Remove the power supply backplane
14.
Disconnect all cables connected to the system board.
15.
Remove the heatsink.
16.
Remove the processor ("Processor" on page 56).
17.
("AC power supply" on page 37).
("Access panel" on page 30).
("Remove the secondary PCIe riser
cage" on page 33).
("Flash-backed write cache
("Fan cage" on page 41).
("Power supply
cage" on page 34,
("Flash-backed write cache capacitor
module" on page 47).
backplane" on page 39).
Removal and replacement procedures 63
"Remove the
pack" on page